Xerox C2424 Service Manual - Page 153
Run the Monitor Sensors test., blade is not covered with ink debris.
UPC - 095205676532
View all Xerox C2424 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 153 highlights
Jam Code Troubleshooting Procedures (Continued) T2Q The exit door open flag unexpectedly tripped when the system picked from Tray 1. T2R The exit door open flag unexpectedly tripped while the system was duplexing. T2S The exit door open flag unexpectedly tripped while the paper was staging for the transfix cycle. T2T The exit door open flag unexpectedly tripped while the print was being transfixed. T2X The exit door open flag unexpectedly tripped while the system was ejecting the print. T2Z The exit door open flag unexpectedly tripped while the system was shutting down. 1. Ensure the media is supported. 2. Ensure ground integrity of the system, see page 4-73. 3. Run the Monitor Sensors test. 4. Inspect the door switch for damage and proper operation. 5. Check the drum maintenance unit to ensure it is functioning properly and the blade is not covered with ink debris. 6. Replace the drum maintenance unit. 7. Replace the transfix roller. V2D V2E V2F V2K V2L V2M V2N V2P V2Q V2R V2S V2T Tray 2 media size sensor unexpectedly activated during warm-up. Tray 2 media size sensor unexpectedly activated during system ready. Tray 2 media size sensor unexpectedly activated while system was in a fault state. Tray 2 media size sensor unexpected event during oil transfix. Tray 2 media size sensor unexpectedly activated while the system was in standby. Tray 2 media size sensor unexpectedly activated while picking from Tray 2. Tray 2 media size sensor unexpectedly activated while picking from Tray 3. Tray 2 media size sensor unexpectedly activated while picking from Tray 4. Tray 2 media size sensor unexpectedly activated while picking from Tray 1. Tray 2 media size sensor unexpectedly activated while Duplexing. Tray 2 media size sensor unexpectedly activated while paper staged for print. Tray 2 media size sensor unexpectedly activated while transfixing the print. Error Messages and Codes 3-61