Xerox C2424 Service Manual - Page 168

Service Diagnostics Main Menu Definition Table (Continued) Menu Item Description Test Name Description Results Test Data Capture Performs the built-in optical test procedure to determine if the system can capture scan dats, the calibration device, the lamp, optics and electronics are functional. OK or Fail. Test Cal Motion Commands the DADF subsystem to move the calibration strip into the scanning window. OK or Fail. Monitor Sensors Paper or no paper. Exercise feed motion Exercises the transport rollers in the DADF. Monitors the paper present sensor. You can manually excercise the sensor flags and verify the results. OK or Fail. There should not be media present to perform this test. Exercise Lamp Cycles the DADF lamp on, then off. The lamp is then left ON. OK or Fail. The lamp state must be manually observed. Reset Doc Handler This test power cycles the IIT unit (MEP, Scanner, DADF). Ready or Not Ready Main Menu --> Control Panel Menu Test Name Description Results Report FW Version Reports the current firmware version. Monitor Buttons Reports each button pressed. Pressed and released. Exercise Display Exercise LEDs Manually press each button. Cycles the display to verify backlight pixels and operation. Exercises each LED (Top to bottom and left to right). All dark = No Backlight All light = Backlight ON ON, Blink, or OFF. 4-10 WorkCentre C2424 Service Manual