Xerox C2424 Service Manual - Page 167

Service Diagnostics Main Menu Definition Table (Continued) Menu Item Test Name Exercise Lamp Exercise Axis Motion Reset Scanner Description Description This tests commands the scanner to cycle the lamp on, then off. The lamp is then left ON. The scanner axis moves to the maximum of its travel position, then back to the home (left) position. This test power cycles the IIT unit (MEP, Scanner, DADF). Results The lamp status must be observed. OK Fail OK or Fail. Ready or Not Ready Main Menu --> Doc Handler Menu Test Name Description Results Report FW Version Reports the current firmware version. Report Status Checks then reports the current status as reported by the DADF unit firmware. Ready or Not Ready Lamp: ON, OFF, Warming Up, Warmup test not done, Test fail Error: OK, Paper Jam, Cover Open, Internal failure, Test fail, Data Capture test fail, Cal Device test fail. Report Paper Status Reports the presence of paper in the DADF unit. Paper or no paper. Perform Selftest This tests performs the builtin self test procedure for the DADF. OK or Fail. (This test may take several minutes to complete.) Test DRAM Tests the DRAM. OK or Fail. (This test may take several minutes to complete.) General Troubleshooting 4-9