Xerox C2424 Service Manual - Page 127
XX.xx Errors - Tray Manager Device Faults, 34,0XX.xx Errors - Printhead NVRAM Faults
UPC - 095205676532
View all Xerox C2424 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 127 highlights
33,0XX.xx Errors - Tray Manager Device Faults 33,001.42: Tray 1 width value too low. 33,002.43: Tray 1 width value too high. Troubleshooting Procedure Step Questions and Actions 1 1. Check the wiring and connectors from the front door to the I/O board. 2. Are the wires connected properly? 2 1. Run the Test Tray 1 Width Sensor test. 2. Did the test pass? Yes Go to Step 2. No Replace the wiring harness. Replace the I/O Replace the board. front door. 34,0XX.xx Errors - Printhead NVRAM Faults 34,001.43: An error occurred while attempting read/write access to the printhead calibration partition in NVRAM. The printhead cable may be unplugged. 34,002.44: An error occurred while attempting read/write access to the printhead ink data partition in NVRAM. 34,003.45: An error occurred while attempting read/write access to the printhead data partition in NVRAM. 34,004.46: An error occurred while accessing the printhead NVRAM hardware for the purpose of initialization. The printhead cable may be unplugged. Troubleshooting Procedure Step Questions and Actions Yes 1 1. Check and reseat all wiring to the printhead. Complete. 2. Did this correct the problem? No Replace in the following order: ■ Printhead ■ Electronics Module. Error Messages and Codes 3-35