Lantronix SGX 5150 IoT Device Gateway SGX 5150 Command Reference - Page 75

6: Commands and Levels initial send binary Sets the accept tunnel Initial Send text allowing for binary characters. = string in binary format that will be sent out the network upon connection. Within [] use binary decimal up to 255 or hex up to 0xFF. initial send set Sets the accept tunnel Initial Send text. = ascii string that will be sent out the network upon connection. kill connection Disconnects the active accept mode tunneling connection. local port Sets the port to use for accept mode tunneling. = number of the port to use. no aes decrypt key Removes the accept tunnel AES decrypt key. no aes encrypt key Removes the accept tunnel AES encrypt key. no credentials Clears the RSA/DSA certificate selection for the SSL server. no email connect Discontinues sending email alerts upon establishing an accept mode tunnel. no email disconnect Discontinues sending email alerts upon closing an accept mode tunnel. no initial send Removes the accept tunnel Initial Send string. no tcp user timeout Restores the default. password Enters the next lower level. protocol ssh Uses SSH protocol for accept mode tunneling. protocol ssl Uses SSL protocol for accept mode tunneling. protocol tcp Uses TCP protocol for accept mode tunneling. protocol tcp aes Uses TCP protocol with AES encryption for accept mode tunneling. protocol telnet Uses Telnet protocol (with IAC) for accept mode tunneling. secure protocols ssl3 disable Disables the protocol. secure protocols ssl3 enable Enables the protocol. secure protocols tls1.0 disable Disables the protocol. secure protocols tls1.0 enable Enables the protocol. secure protocols tls1.1 disable Disables the protocol. secure protocols tls1.1 enable Enables the protocol. secure protocols tls1.2 disable Disables the protocol. secure protocols tls1.2 enable Enables the protocol. show Displays the current configuration. show history Displays the last 20 commands entered during the current CLI session. show status Displays tunnel accept status. start character Sets the accept mode start character. The character may be input as text, control, decimal, or hex. A control character has the form C. A decimal value character has the form \99. A hex value character has the form 0xFF. tcp keep alive Sets the TCP keep alive time. This is the initial keep alive timeout. = timer value, in milliseconds. tcp keep alive interval Enables TCP keep alive for accept mode tunneling and sets the timer. = TCP keep alive for accept mode in milliseconds. tcp keep alive probes Sets the number of TCP keep alive probes. = number of TCP keep alive probes. tcp user timeout Sets the timeout for TCP retransmissions. = timeout value, in milliseconds. tunnel buffer size Sets the maximum tunnel data to be buffered. = buffer size, in Mbytes. tunnel buffer state disable Disables buffering of tunnel data. tunnel buffer state enable Enables buffering of tunnel data when network connection is lost or not established. write Stores the current configuration in permanent memory. access point (config-access-point) level commands channel Sets the channel on which the Access Point will operate. channel selection automatic Sets channel selection to automatic. channel selection configured Sets channel selection to configured. clrscrn Clears the screen. default channel Clears the Access Point channel setting. default channel selection Sets to default channel selection, which is 'Automatic'. SGX™ 5150 IoT Device Gateway Command Reference 75