Lantronix SGX 5150 IoT Device Gateway SGX 5150 Command Reference - Page 15
IoT Device Gateway Command Reference, Commands and Levels
View all Lantronix SGX 5150 IoT Device Gateway manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
3: Command Line Interface Commands at the login level (see Figure 3-2 below) do not affect current configuration settings and are not displayed initially. If you type ?, you will see the login subcommands. These commands provide diagnostic and status information only. Figure 3-2 Login Level Commands admin@SGX5150-0080a3b028b6>? clrscrn iperf ping ping6 ping6 show history show multicast routes show rules trace route enable exit ping ping ping6 show show lines show routes tcpdump trace route Note: To configure the SGX 5150 IoT device gateway, you must be in the enable level and any of its sub-levels. Figure 3-3 below shows the enable level commands. Figure 3-3 Enable Level Commands admin@SGX5150-0080a3b028b6(enable)#? auto show interfaces bluetooth serial configure connect line disable email filesystem kill ssh line ping ping6 ping6 reload factory defaults show show interfaces show lines show processes show rules ssh ssh tcpdump telnet trace route usb xml auto show processes clrscrn connect device dns exit iperf kill telnet ping ping ping6 reload reload to standalone firmware installer show history show ip sockets show multicast routes show routes show sessions ssh ssl telnet trace route tunnel write See Chapter 6: Commands and Levels for a complete list of levels, commands, and descriptions. SGXTM 5150 IoT Device Gateway Command Reference 15