Lantronix SGX 5150 IoT Device Gateway SGX 5150 Command Reference - Page 215
Disables WiFi Direct Group Owner Mode.
View all Lantronix SGX 5150 IoT Device Gateway manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 215 highlights
6: Commands and Levels local port Sets the local port for ConsoleFlow client. When configured, a total of 16 consecutive ports will be reserved. no project tag Restores the default Project Tag. project tag Sets the Project Tag. show Displays the current configuration. show history Displays the last 20 commands entered during the current CLI session. state disable Disables command processing on line. state enable Enables command processing on line. status update interval Sets the status update interval. write Stores the current configuration in permanent memory. link (config-wlan:wlan0) level commands antenna diversity antenna 1 Set antenna selection to 1 antenna diversity antenna 2 Set antenna selection to 2 antenna diversity enabled Set antenna diversity to enabled. apply wlan Try out WLAN settings without saving them to Flash. If the settings do not work, when you reboot the device, it will still have the original settings. band 2.4 ghz only Sets the radio band to 2.4 GHz only. band 5 ghz only Sets the radio band to 5 GHz only. band auto Sets the radio band to Auto. cancel wps Cancels wi-fi protected setup operation. choice Enters the next lower level. Specify the instance for the next lower level. clrscrn Clears the screen. debugging level debug Sets the WLAN debugging level to Debug. debugging level dump Sets the WLAN debugging level to Dump, the most verbose option. debugging level error Sets the WLAN debugging level to Error, which shows only errors. debugging level info Sets the WLAN debugging level to Info. debugging level warning Sets the WLAN debugging level to Warning. default antenna diversity Restore the default value for antenna diversity. default band Restores the radio band to the default value (Auto). default debugging level Sets the WLAN debugging level to its default value, Info. default scanning latency Restores scanning latency to the default value (Standard). exit Exit back to interface configuration level no scanning channel list Clears the scanning channel list. scan Scan the radio environment for networks. scanning channel list Sets the scanning channel list. scanning latency enhanced throughput Sets scanning latency to Enhanced Throughput. scanning latency standard Sets scanning latency to Standard. show Displays the current configuration. show history Displays the last 20 commands entered during the current CLI session. show wps information Show the configuration received by wi-fi protected setup. show wps information with secrets Show the configuration received by wi-fi protected setup with secrets. show wps status Show status of WPS operation. smartroam Enter smartroam configuration level start wps Starts wi-fi protected setup operation. start wps pin Starts wi-fi protected setup operation. status Show link status wifi direct go mode disable Disables WiFi Direct Group Owner Mode. wifi direct go mode enable Enables WiFi Direct Group Owner Mode. write Stores the current configuration in permanent memory. link (config-ethernet:eth0) level commands SGX™ 5150 IoT Device Gateway Command Reference 215