Lantronix SGX 5150 IoT Device Gateway SGX 5150 Command Reference - Page 11
: Command Line Interface, Configuration Using Telnet, Configuration Using the Serial Lines
View all Lantronix SGX 5150 IoT Device Gateway manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
3: Command Line Interface This chapter describes accessing the SGX 5150 IoT device gateway by using Telnet, SSH, or serial ports to configure the gateway, navigating the CLI, typing keyboard shortcuts, and moving between the levels. It contains the following sections: Configuration Using Telnet Configuration Using the Serial Lines Navigating the CLI Hierarchy Using Keyboard Shortcuts and CLI Understanding the CLI Level Hierarchy See Chapter 6: Commands and Levels for a complete list of levels, commands, and descriptions. Configuration Using Telnet To access and configure the SGX 5150 IoT device gateway by using a Telnet session over the network, you must first establish a Telnet connection. You can also establish a Telnet connection by clicking the Telnet Configuration tab in the Lantronix® DeviceInstaller™ utility. See the DeviceInstaller Online Help for more information. To access the SGX 5150 IoT device gateway by using Telnet, perform the following steps. 1. Click Start > Run. The Run dialog box displays. 2. Type cmd in the dialog box and press OK. 3. Type telnet x.x.x.x (x.x.x.x is the IP address) in a Windows/Linux command prompt. 4. The SGX 5150 IoT device gateway is online when the command prompt (>) displays. You are at the root level of the CLI. Note: Depending on the level of security, a password may be required. Configuration Using the Serial Lines Serial Command Mode The serial port can be configured to operate in command mode permanently or to be triggered under specified conditions. See the line Level command description for more information. Serial Recovery Serial Recovery mode will temporarily override line settings for the serial line to allow configuration changes to be made. Line settings will be restored once the user exits the Serial Recovery mode CLI. Note: Serial Recovery mode is not available if Early Initialization is enabled on the serial line. See the SGX 5150, SGX 5150 MD, and SGX 5150 XL IoT Device Gateway User Guide available at www.lantronix.com/support/documentation for additional information. SGXTM 5150 IoT Device Gateway Command Reference 11