Lantronix SGX 5150 IoT Device Gateway SGX 5150 Command Reference - Page 221

6: Commands and Levels clrscrn Clears the screen. default packing mode Sets to default packing mode, which is 'Disable' default send character Removes the send character for packing mode. default threshold Restores the default threshold. default timeout Restores the default packing mode timeout. exit Returns to the tunnel level. no trailing character Removes the trailing character for packing mode. packing mode disable Disables packing. Data is sent to the network when received. packing mode send character Sets packing mode to accumulate data and transmit it upon receiving the configured send character on the line (serial port). packing mode timeout Sets packing mode to accumulate data and transmit it after a specified amount of time (timeout). send character Sets the send character for packing mode. The character may be input as text, control, decimal, or hex. A control character has the form C. A decimal value character has the form \99. A hex value character has the form 0xFF. show Displays the current configuration. show history Displays the last 20 commands entered during the current CLI session. threshold Sets the threshold (byte count). If the queued data reaches this threshold then the data will be sent. = number of bytes in the threshold. timeout Sets the timeout value for packing mode in milliseconds. = timeout value, in milliseconds. trailing character Sets the trailing character for packing mode. The character may be input as text, control, decimal, or hex. A control character has the form C. A decimal value character has the form \99. A hex value character has the form 0xFF. write Stores the current configuration in permanent memory. password (tunnel-accept-password: ) level commands ( is the number of the line) clrscrn Clears the screen. exit Exits to the next higher level. no password Removes the password so connections will be accepted unchallenged. password Sets the password required on the network side of the tunnel to begin a connection. prompt disable Inhibits any prompting for password on the network side of the tunnel. prompt enable Sets up so a user on the network side of the tunnel will be prompted for a password. show Shows the current configuration. show history Displays the last 20 commands entered during the current CLI session. write Stores the current configuration in permanent memory. port forwarding rule 1 (config-portforwarding:1) level commands clrscrn Clears the screen. default protocol Restores the default value of the protocol (Both). exit Exits to the config-gateway level. friendly name Set the friendly name for port forwarding rule = friendly name ingress ip address Sets the original WAN destination IP address for port forwarding rule. ip address Sets the LAN destination IP address for port forwarding rule. no friendly name Remove the friendly name. no ingress ip address Clears the original WAN destination IP address for port forwarding rule. no ip address Clears the LAN destination IP address for port forwarding rule. no port or range Clears the WAN port or range for port forwarding rule. no target port Clears the LAN destination port for port forwarding rule. port forwarding rule Change to config gateway port forwarding level. port or range Sets the WAN port or range for port forwarding rule. = port or range. protocol both Sets the protocol to Both (TCP and UDP). protocol tcp Sets the protocol to TCP. protocol udp Sets the protocol to UDP. show Displays the current configuration. SGX™ 5150 IoT Device Gateway Command Reference 221