Kyocera ECOSYS M4125idn M4125idn/M4132idn Operation Guide - Page 438
Auto-IP], the IP, Symptom, Checkpoints, Corrective Actions, Reference
View all Kyocera ECOSYS M4125idn manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 438 highlights
Troubleshooting > General Troubles Symptom Printouts are curled. The printer driver won't install. Cannot print. Cannot print with USB memory. USB memory not recognized. While "On" is set to [Auto-IP], the IP address is not assigned automatically. Checkpoints Corrective Actions Reference Page ― Is the paper damp? While Wi-Fi or the Wi-Fi Direct function is enabled, are you trying to install the driver using the host name? Remove the paper from the cassette, 3-18 turn the stack over, and reload the paper. You can also try turning the paper around 180 degrees. Replace the paper with new paper. 3-17 If the problem occurs frequently, turn 2-5 on the Cassette Heater switch. Instead of the host name, specify the 2-28 IP address. Check the power cord. Is the machine powered on? Connect both ends of the power cord 2-9 securely. Turn on the power switch. 2-10 Are the USB cable and network cable Connect the correct USB cable and 2-9 connected? network cable securely. 2-9 Is the print job paused? If wired or Wi-Fi network settings were configured using name resolution, is there intermixing with an IP address (private address) of another network that cannot access? Resume printing. Only one host name and one domain name can be used with the MFP. Configure network settings keeping this restriction in mind. Use Command Center RX to change the NetBEUI, DNS, and other name resolution settings, or change the network environment settings. 7-9 ― CommandCen ter RX User Guide On the Primary Network (Client), 8-50 select Wi-Fi, Wired Network, or Optional Network as an unlimited-use network. With the protocol settings, select 8-40 [Enable] for either the [Wired Network] or [Wi-Fi] setting, and [Disable] for the other setting. Is the USB host blocked[Block]? Select [Unblock] in the USB host 8-50 settings. ― Check that the USB memory is ― securely plugged into the machine. Is a value other than "0.0.0.0" entered for the IP address of TCP/ IP(v4)? Enter "0.0.0.0" for the IP address of 2-13 TCP/IP(v4). 11-4