Epson ColorWorks C7500 ESC/label Command Reference Guide - Page 93
ESC/Label Command Reference Guide, Rev. E,
View all Epson ColorWorks C7500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 93 highlights
i# Character code to undergo the 0 ≤ i# ≤ 255 mapping change [Function] Sets the link between the input character code and the rendered characters. The character code set used in character rendering is set based on Parameter a. The character code specified in Parameter i# is replaced with the character code specified in Parameter o#. Up to 256 replacements can be set. [Response] None [Note] If 14, 15, 16, 24, or 26 is specified for Parameter a, a character code conversion table that supports the character code set is required. Use "^SE" to enable the supporting character code conversion table. [Reference] Related commands: ^SE ESC/Label Command Reference Guide Rev. E Page 93
ESC/Label Command Reference Guide
Rev. E
Page 93
i#
Character code to undergo the
mapping change
0 ≤ i# ≤ 255
[Function]
Sets the link between the input character code and the rendered characters.
The character code set used in character rendering is set based on Parameter a.
The character code specified in Parameter i# is replaced with the character code specified in
Parameter o#.
Up to 256 replacements can be set.
[Response]
None
[Note]
If 14, 15, 16, 24, or 26 is specified for Parameter a, a character code conversion table that supports the
character code set is required.
Use "^SE" to enable the supporting character code conversion table.
[Reference]
Related commands: ^SE