3Com 5500G-EI Command Reference Guide - Page 388

388 CHAPTER 11: USING AAA AND RADIUS COMMANDS Example To allow the real-time accounting request failing to be responded for up to 10 times, enter the following: system-view System View: return to User View with Ctrl+Z. [SW5500]radius scheme 3Com [SW5500-radius-3Com]retry realtime-accounting 10 retry stop-accounting Syntax retry stop-accounting retry-times undo retry stop-accounting View RADIUS Scheme View Parameter retry-times: Specifies the maximal retransmission times after stopping accounting request,. ranging from 10 to 65535. By default, the value is 500. Description Use the retry stop-accounting command to configure the maximal retransmission times after stopping accounting request. Use the undo retry stop-accounting command to restore the retransmission times to the default value. Because the stopping accounting request concerns account balance and will affect the amount of charge, which is very important for both the user and ISP, NAS shall make its best effort to send the message to RADIUS accounting server. Accordingly, if the message from the Switch to RADIUS accounting server has not been responded, the Switch shall save it in the local buffer and retransmit it until the server responds or discard the messages after transmitting for specified times. Related commands: reset stop-accounting-buffer, radius scheme, display stop-accounting-buffer. Example To indicate that, when stopping accounting request for the server "3Com" in the RADIUS server group, the Switch will retransmit the packets for up to 1000 times, enter the following: system-view System View: return to User View with Ctrl+Z. [SW5500]radius scheme 3Com [SW5500-radius-3Com]retry stop-accounting 1000 secondary accounting Syntax secondary accounting ip-address [ port-number ] undo secondary accounting View RADIUS Scheme View