3Com 5500G-EI Command Reference Guide - Page 162

162 CHAPTER 6: USING ROUTING PROTOCOL COMMANDS Table 23 Description of the display rip interface Command Field Description Address The IP address of the interface which runs RIP protocol (you should enable the network segment in which this address resides using the network command in RIP protocol view) Interface Name of the inteface which runs RIP protocol. The IP address of this inteface corresponds to the IP address of the Address field. Ver Version of the RIP protocol running on an interface Metrin/Out Cost of additional route which is added when sending or receiving routes. Input Allow/disallow the interface to receive RIP packets: on for allow, off for disallow. Output Allow/disallow the interface to send RIP packets: on for allow, off for disallow. Split-horizon The split-horizon is enabled or disabled: on for enabled, off for disabled. display rip routing Syntax display rip routing View All views Parameter None Description Use the display rip routing command to view RIP routing information. Example To display rip routing information, enter the following: display rip routing RIP routing table: public net Destination/Mask Cost NextHop 10.3.4.0/32 1 1.1.1.1 11.0.0.0/8 1 1.1.1.1 Age SourceGateway 10s 1.1.1.1 10s 1.1.1.1 Table 24 Description of the display rip routing Command Field Description Destination/Mask Length of the destination addresss/mask Cost Route cost NextHop Nexthop address of a route Age Existing time of a route in the routing table (aging time) SourceGateway Source gateway address. The route is learnt from the gateway with this address.