3Com 5500G-EI Command Reference Guide - Page 112
Resilient ARP, Configuration, Commands, Description, Example, debugging resilient-arp, Syntax
UPC - 662705493534
View all 3Com 5500G-EI manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 112 highlights
112 CHAPTER 5: USING NETWORK PROTOCOL COMMANDS Description Use the reset arp command to remove information that is no longer required from the ARP mapping table. You can remove entries of a specified type, or from a specified port. Use the reset arp command to clear all ARP entries. You are asked to confirm this entry. Use the reset arp dynamic command to clear all dynamic ARP entries. Use the reset arp static command to clear all static ARP entries. Use the display arp interface command to clear all entries for the specified port. Related command: arp static, display arp. Example To clear static ARP entries, enter the following: reset arp static Resilient ARP Configuration Commands This section describes the commands you can use to configure and manage the Resilient ARP operations debugging resilient-arp Syntax debugging resilient-arp { packet | state | error | all } undo debugging resilient-arp { packet | state | error | all } View User view Parameters packet Enter to enable debugging resilient ARP packets. state Enter to enable debugging resilient ARP state machine. error Enter to enable debugging resilient ARP errors (including packet errors). all Enter to enable all resilient ARP debugging. Description Use the debugging resilient-arp command to enable resilient ARP debugging. Use the undo debugging resilient-arp command to disable resilient ARP debugging. By default, all resilient ARP debugging is disabled.