3Com 5500G-EI Command Reference Guide - Page 110

110 CHAPTER 5: USING NETWORK PROTOCOL COMMANDS Table 9 Output Description of the debugging arp packet Command Field operation sender_eth_addr sender_ip_addr target_eth_addr target_ip_addr Description Type of ARP packets: 1 ARP request packet; 2 ARP reply packet Ethernet address of the sender IP address of the sender Target Ethernet address. If the packet is ARP request packet, the target IP address will be 0 Target IP address display arp Syntax display arp [ ip-address | [ dynamic | static ] [ | { begin | include | exclude } text ]] View All views Parameters dynamic Enter to display the dynamic ARP entries in the ARP mapping table. static Enter to display the static ARP entries in the ARP mapping table. begin Enter to start displaying from the first ARP entry that contains the specified character string "text". include Enter to display only the ARP entries that contain the specified character string "text". exclude Enter to display only the ARP entries that do not contain the specified character string "text". text Enter a character string. The ARP entries that contain this character string are displayed. Description Use the display arp command to display the ARP mapping table entries by entry type, or by a specified IP address. Related commands: arp static, reset arp. Example To display all ARP entries in the mapping table, enter the following: display arp Type: S-Static D-Dynamic IP Address MAC Address 161.71.61.20 0020-9c08-e774 VLAN ID Port Name / AL ID Aging Type 1 GigabitEthernet2/0/6 20 D --- 1 entry found --