3Com 5500G-EI Command Reference Guide - Page 113
Example, display resilient-arp, Syntax, Parameter, Description, resilient-arp enable
UPC - 662705493534
View all 3Com 5500G-EI manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 113 highlights
Resilient ARP Configuration Commands 113 Example To enable debugging resilient ARP packets, enter the following: debugging resilient-arp packet display resilient-arp Syntax display resilient-arp [ unit unit-id ] View Any view Parameter unit-id Enter the unit ID, in the range of 1 to 8. Description Use the display resilient-arp command to view resilient ARP state information of the units, the resilient ARP packet-sending VLAN interfaces. If no unit ID is specified, the system displays the resilient ARP state information of all units. Otherwise, the system only displays the resilient ARP state information of the designated units. Example To display resilient ARP state information of Unit 1, enter the following: display resilient-arp unit 1 The state of unit 1 is: L3Master The sending interface(s): Vlan-interface1 resilient-arp enable Syntax resilient-arp enable undo resilient-arp enable View System View Parameter None Description Use the resilient-arp enable command to enable the resilient ARP function. Use the undo resilient-arp enable command to disable the resilient ARP function. By default, resilient ARP function is enabled. For the related command, see display resilient-arp.