3Com 5500G-EI Command Reference Guide - Page 366

366 CHAPTER 11: USING AAA AND RADIUS COMMANDS idle-cut Syntax idle-cut { disable | enable minute flow } View ISP Domain View Parameter disable: means disabling the user to use idle-cut function . enable: means enabling the user to use the function. minute: Specifies the maximum idle time, ranging from 1 to 120 and measured in minutes. flow: The minimum data traffic, ranging from 1 to 10,240,000 and measured in bytes. Description Use the idle-cut command to configure the user template in the current ISP domain. By default, after an ISP domain is created, this attribute in user template is disable, that is, the user idle-cut is disabled. The user template is a set of default user attributes. If a user requesting for the network service does not have some required attributes, the corresponding attributes in the template will be endeavored to him as default ones. The user template of the Switch you are using may only provide user idle-cut settings. After a user is authenticated, if the idle-cut is configured to enable or disable by neither the user nor the RADIUS server, the user will adopt the idle-cut state in the template. Because a user template only works in one ISP domain, it is necessary to configure user template attributes for users from different ISP domain respectively. Related command: domain Example To enable the user in the current ISP domain, 3Com163.net, to use the idle-cut attribute specified in the user template (that is, enabling the user to use the idle-cut function). The maximum idle time is 50 minutes and the minimum data traffic is 500 bytes. system-view System View: return to User View with Ctrl+Z. [SW5500]domain marlboro.net [SW5500-isp-marlboro.net]idle-cut enable 50 500 level Syntax level level undo level