3Com 5500G-EI Command Reference Guide - Page 160

160 CHAPTER 6: USING ROUTING PROTOCOL COMMANDS Example To configure the Switch not to perform zero checking for RIP-1 packet, enter the following: system-view System View: return to User View with Ctrl+Z. [SW5500]rip [SW5500-rip]undo checkzero default cost Syntax default cost value undo default cost View RIP view Parameter value Enter the default routing cost, in the range 1 to 16. The default is 1. Description Use the default cost command to set the default routing cost of an imported route. Use the undo default cost command to restore the default value. If you do not specify a routing cost when using the import-route command, the default cost you specify here is used. Related command: import-route. Example To set the default routing cost of the imported route of another routing protocol to 3, enter the following: system-view System View: return to User View with Ctrl+Z. [SW5500]rip [SW5500-rip]default cost 3 display rip Syntax display rip View All Views Parameter None Description Use the display rip command to view the current RIP running state and its configuration information.