2002 Ducati MH900e 900e Owners Manual - Page 84

Setting the gear change pedal (fig. 11.2) The gear change and rear brake pedals can be adjusted to suit the preferred riding position of each rider. To set the gear change pedal, lock linkage (1) and loosen the check nuts (2) and (3). Note Nut (2) has a left-hand thread. 3 E 2 Rotate linkage (1) until setting the gear change pedal in the desired position. Tighten both check nuts onto linkage. 1 Setting the rear brake pedal (fig. 11.3) To set the rear brake pedal, loosen check nut (4). Turn the pedal travel adjusting screw (5) until pedal is in the desired position. Tighten check nut (4). Work pedal by hand to make sure it has 1.5 - 2 mm free play before brake begins to bite. If not so, set the length of master cylinder linkage as follows. Loosen the check nut (6) on master cylinder linkage. Tighten linkage into fork (7) to increase play, or unscrew linkage to reduce it. Tighten check nut (6) and check pedal free play again. 18 fig. 11.2 6 7 4 5 fig. 11.3