Netgear XSM4324CS CLI Manual Software Version 12.x - Page 825
ipv6 route distance, ipv6 route net-prototype, ipv6 route, distance
View all Netgear XSM4324CS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 825 highlights
M4300 Intelligent Edge Series Fully Managed Stackable Switches no ipv6 route Use this command to delete an IPv6 static route. Use the command without the optional parameters to delete all static routes to the specified destination. Use the preference parameter to revert the preference of a route to the default preference. Format Mode no ipv6 route ipv6-prefix/prefix_length [{next-hop-address | Null0 | interface {unit/slot/port| vlan vland-id | tunnel tunnel_id} next-hop-address} [preference]] Global Config ipv6 route distance This command sets the default distance (preference) for IPv6 static routes. Lower route distance values are preferred when determining the best route. The ipv6 route distance command lets you optionally set the distance (preference) of an individual static route. The default distance is used when no distance is specified in this command. The preference can be a number in the range 1-255. Changing the default distance does not update the distance of existing static routes, even if they were assigned the original default distance. The new default distance will only be applied to static routes created after entering the ipv6 route distance command. Default Format Mode 1 ipv6 route distance preference Global Config no ipv6 route distance This command resets the default static route preference value in the router to the original default preference. Lower route preference values are preferred when determining the best route. Format Mode no ipv6 route distance Global Config ipv6 route net-prototype This command adds net prototype IPv6 routes to the hardware. Use the prefix/prefix-length argument to specify the The destination network and mask for the route. Use the nexthopip argument to specify the next-hop IP address, which must belong to an active routing interface but it does not need to be resolved. The routes are added starting from the specified prefix and prefix-length. IPv6 Commands 825 CLI Command Reference Manual