Netgear XSM4324CS CLI Manual Software Version 12.x - Page 213
show running-config interface, If all the flags are enabled, then the command displays
View all Netgear XSM4324CS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 213 highlights
M4300 Intelligent Edge Series Fully Managed Stackable Switches Use the following keys to navigate the command output. Key Enter Space Bar q Action Advance one line. Advance one page. Stop the output and return to the prompt. Note that --More-- or (q)uit is displayed at the bottom of the output screen until you reach the end of the output. This command captures the current settings of OSPFv2 and OSPFv3 trapflag status: • If all the flags are enabled, then the command displays trapflags all. • If all the flags in a particular group are enabled, then the command displays trapflags group name all. • If some, but not all, of the flags in that group are enabled, the command displays trapflags groupname flag-name. Format Mode show running-config [all | scriptname] Privileged EXEC show running-config interface Use this command to display the running configuration for a specific interface. Valid interfaces include physical, LAG, loopback, tunnel and VLAN interfaces. Format Mode show running-config interface {unit/slot/port | lag lag-intf-num | loopback loopback-id | tunnel tunnel-id | vlan vlan-id} Privileged EXEC Parameter interface lag-intf-num loopback-id tunnel-id vlan-id Description Running configuration for the specified interface. Running configuration for the LAG interface. Running configuration for the loopback interface. Running configuration for the tunnel interface. Running configuration for the VLAN routing interface. Utility Commands 213 CLI Command Reference Manual