Netgear XSM4324CS CLI Manual Software Version 12.x - Page 716
ip helper enable, show ip helper-address, bootpdhcprelay enable
View all Netgear XSM4324CS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 716 highlights
M4300 Intelligent Edge Series Fully Managed Stackable Switches (NETGEAR Switch)(interface 1/0/2)#ip helper-address 192.168.40.2 domain (NETGEAR Switch)(interface 1/0/2)#exit (NETGEAR Switch)(config)#interface 1/0/17 (NETGEAR Switch)(interface 1/0/17)#ip helper-address 192.168.23.1 162 (NETGEAR Switch)(interface 1/0/17)#ip helper-address discard dhcp no ip helper-address (Interface Config) Use this command to delete a relay entry on an interface. The command without any arguments clears all helper addresses on the interface. Format Mode no ip helper-address [server-address | discard] [dest-udp-port | dhcp | domain | isakmp | mobile ip | nameserver | netbios-dgm | netbios-ns | ntp | pim-auto-rp | rip | tacacs | tftp | time] Interface Config ip helper enable Use this command to enable relay of UDP packets. This command can be used to temporarily disable IP helper without deleting all IP helper addresses. This command replaces the bootpdhcprelay enable command, but affects not only relay of DHCP packets, but also relay of any other protocols for which an IP helper address has been configured. Default Format Mode disabled ip helper enable Global Config Command example: (NETGEAR Switch)(config)#ip helper enable no ip helper enable Use the no form of this command to disable relay of all UDP packets. Format Mode no ip helper enable Global Config show ip helper-address Use this command to display the IP helper address configuration. The argument unit/slot/port corresponds to a physical routing interface or VLAN routing interface. The argument unit/slot/port corresponds to a physical routing interface or VLAN routing Routing Commands 716 CLI Command Reference Manual