Netgear XSM4324CS CLI Manual Software Version 12.x - Page 72
Telnet Commands
View all Netgear XSM4324CS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 72 highlights
M4300 Intelligent Edge Series Fully Managed Stackable Switches show serial This command displays serial communication settings for the switch. Format Modes show serial • Privileged EXEC • User EXEC Term Definition Serial Port Login Timeout The time, in minutes, of inactivity on a serial port connection, after which the switch will close (minutes) the connection. A value of 0 disables the timeout. Baud Rate (bps) The default baud rate at which the serial port will try to connect. Character Size (bits) The number of bits in a character. The number of bits is always 8. Flow Control Whether Hardware Flow-Control is enabled or disabled. Hardware Flow Control is always disabled. Stop Bits The number of Stop bits per character. The number of Stop bits is always 1. Parity The parity method used on the Serial Port. The Parity Method is always None. Telnet Commands This section describes the commands you use to configure and view Telnet settings. You can use Telnet to manage the device from a remote management host. ip telnet server enable Use this command to enable Telnet connections to the system and to enable the Telnet Server Admin Mode. This command opens the Telnet listening port. Default Format Mode enabled ip telnet server enable Privileged EXEC no ip telnet server enable Use this command to disable Telnet access to the system and to disable the Telnet Server Admin Mode. This command closes the Telnet listening port and disconnects all open Telnet sessions. Format Mode no ip telnet server enable Privileged EXEC Management Commands 72 CLI Command Reference Manual