Netgear XSM4324CS CLI Manual Software Version 12.x - Page 579
set igmp proxy-querier, and the information for all Querier-enabled VLANs.
View all Netgear XSM4324CS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 579 highlights
M4300 Intelligent Edge Series Fully Managed Stackable Switches When the optional argument vlan-id is not used, the command displays the following information. Field Admin Mode Admin Version Querier Address Query Interval Querier Timeout Description Indicates whether or not IGMP Snooping Querier is active on the switch. The version of IGMP that will be used while sending out the queries. The IP Address which will be used in the IPv4 header while sending out IGMP queries. It can be configured using the appropriate command. The amount of time in seconds that a Snooping Querier waits before sending out the periodic general query. The amount of time to wait in the Non-Querier operational state before moving to a Querier state. When you specify a value for vlan-id, the following additional information displays. Field Description VLAN Admin Mode Indicates whether iGMP Snooping Querier is active on the VLAN. VLAN Operational Indicates whether IGMP Snooping Querier is in "Querier" or "Non-Querier" state. When the switch is State in Querier state, it will send out periodic general queries. When in Non-Querier state, it will wait for moving to Querier state and does not send out any queries. VLAN Operational Indicates the time to wait before removing a Leave from a host upon receiving a Leave request. This Max Response value is calculated dynamically from the Queries received from the network. If the Snooping Switch Time is in Querier state, then it is equal to the configured value. Querier Election Participation Indicates whether the IGMP Snooping Querier participates in querier election if it discovers the presence of a querier in the VLAN. Querier VLAN Address The IP address will be used in the IPv4 header while sending out IGMP queries on this VLAN. It can be configured using the appropriate command. Operational Version The version of IPv4 will be used while sending out IGMP queries on this VLAN. Last Querier Address Indicates the IP address of the most recent Querier from which a Query was received. Last Querier Version Indicates the IGMP version of the most recent Querier from which a Query was received on this VLAN. When the optional argument detail is used, the command shows the global information and the information for all Querier-enabled VLANs. set igmp proxy-querier If a non-querier switch receives an IGMP leave message, the non-querier switch can send queries with 0::0 as source IP addresses. This command enables the switch to send such proxy queries through different command modes in the following ways: • in Global Config mode, on the entire switch Switching Commands 579 CLI Command Reference Manual