Netgear XSM4324CS CLI Manual Software Version 12.x - Page 376
Expandable Port Configuration Commands for 40G Ports on the APM402XL Port Card, debug dynamic ports
View all Netgear XSM4324CS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 376 highlights
M4300 Intelligent Edge Series Fully Managed Stackable Switches debug dynamic ports This command enables debug messages that are related to dynamic ports, that is, combo ports that are capable of detecting the media type (SFP [fiber] or Ethernet [copper]). Format Mode debug dynamic ports Privileged EXEC no debug dynamic ports This command disables debug messages that are related to dynamic ports, that is, combo ports that are capable of detecting the media type (SFP [fiber] or Ethernet [copper]). Format Mode no debug dynamic ports Privileged EXEC Expandable Port Configuration Commands for 40G Ports on the APM402XL Port Card This section describes the commands that you can use to view and configure expandable port settings. By default, the 40G ports on the APM402XL port card (that is, port 1 and port 5) are active, which means that they are in the attached state, can be detected, and you can use them. The expandable 10G ports on the APM402XL port card (that is, ports 2-4 on the first 40G port and ports 6-8 on the second 40G port) are nonactive, which means that they are in the detached state and you cannot use them. In the following example, the output of the show port all command for the APM402XL port card displays the following: • The first 40G port is configured as four expendable 10G ports with port numbers 1/1/1 to 1/1/4, the ports are in the active state, and the link status for each port is up. • The second 40G port is in its default configuration, the 40G port number is 1/1/5, the port is in the active state, and the link status is down. The expandable 10G ports 1/1/6 to 1/1/8 are in the nonactive state, which means that they are in the detached state and you cannot use them. (Netgear Switch) #show port all Admin Physical Physical Link Link LACP Flow Intf Type Mode Mode Status Status Trap Mode Mode 1/1/1 Enable 10G Full 10G Full Up Enable Enable Disable 1/1/2 Enable 10G Full 10G Full Up Enable Enable Disable 1/1/3 Enable 10G Full 10G Full Up Enable Enable Disable 1/1/4 Enable 10G Full 10G Full Up Enable Enable Disable Switching Commands 376 CLI Command Reference Manual