Netgear XSM4324CS CLI Manual Software Version 12.x - Page 482
storm-control broadcast action, shutdown
View all Netgear XSM4324CS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 482 highlights
M4300 Intelligent Edge Series Fully Managed Stackable Switches no storm-control broadcast Use this command to disable broadcast storm recovery mode for all interfaces (Global Config mode) or one or more interfaces (Interface Config mode). Format Mode no storm-control broadcast Global Config Interface Config storm-control broadcast action This command configures the broadcast storm recovery action to either shut down or send traps for one, several, or all interfaces. If you enter the command in Global Config mode, the action applies to all interfaces. If you enter the command in Interface Config mode, the action applies to or one or more interfaces. If you specify the shutdown keyword, the interface that receives the broadcast packets at a rate above the threshold is diagnostically disabled. If you specify the trap keyword, the interface sends trap messages approximately every 30 seconds until broadcast storm control recovers. Format Mode storm-control broadcast action {shutdown | trap} Global Config Interface Config no storm-control broadcast action This command sets the broadcast storm recovery action to the default value for one, several, or all interfaces. If you enter the command in Global Config mode, the action applies to all interfaces. If you enter the command in Interface Config mode, the action applies to or one or more interfaces. Format Mode no storm-control broadcast action Global Config Interface Config storm-control broadcast level Use this command to configure the broadcast storm recovery threshold for all interfaces (Global Config mode) or one or more interfaces (Interface Config mode) as a percentage of link speed and enable broadcast storm recovery. If the mode is enabled, broadcast storm recovery is active, and if the rate of L2 broadcast traffic ingressing on an interface increases beyond the configured threshold, the traffic is dropped. Therefore, the rate of broadcast traffic is limited to the configured threshold. The threshold level can be in the range from 0-100. The default is 5. Switching Commands 482 CLI Command Reference Manual