Netgear XSM4324CS CLI Manual Software Version 12.x - Page 525
macfilter adddest, 80:C2:00:00:00 to 01:80:C2:00:00:0F,
View all Netgear XSM4324CS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 525 highlights
M4300 Intelligent Edge Series Fully Managed Stackable Switches The value of the macaddr parameter is a 6-byte hexadecimal number in the format of b1:b2:b3:b4:b5:b6. The restricted MAC Addresses are: 00:00:00:00:00:00, 01:80:C2:00:00:00 to 01:80:C2:00:00:0F, 01:80:C2:00:00:20 to 01:80:C2:00:00:21, and FF:FF:FF:FF:FF:FF. The vlanid parameter must identify a valid VLAN. The number of static mac filters supported on the system is different for MAC filters where source ports are configured and MAC filters where destination ports are configured. • For unicast MAC address filters and multicast MAC address filters with source port lists, the maximum number of static MAC filters supported is 20. • For multicast MAC address filters with destination ports configured, the maximum number of static filters supported is 256. For example, you can configure the following combinations: • Unicast MAC and source port (max = 20) • Multicast MAC and source port (max = 20) • Multicast MAC and destination port (only) (max = 256) • Multicast MAC and source ports and destination ports (max = 20) Format Mode macfilter macaddr vlanid Global Config no macfilter This command removes all filtering restrictions and the static MAC filter entry for the MAC address macaddr on the VLAN vlanid. The macaddr parameter must be specified as a 6-byte hexadecimal number in the format of b1:b2:b3:b4:b5:b6. The vlanid parameter must identify a valid VLAN. Format Mode no macfilter macaddr vlanid Global Config macfilter adddest Use this command to add the interface or range of interfaces to the destination filter set for the MAC filter with the given macaddr and VLAN of vlanid. The macaddr parameter must be specified as a 6-byte hexadecimal number in the format of b1:b2:b3:b4:b5:b6. The vlanid parameter must identify a valid VLAN. Note: Configuring a destination port list is only valid for multicast MAC addresses. Switching Commands 525 CLI Command Reference Manual