Netgear XSM4324CS CLI Manual Software Version 12.x - Page 1006
priority-flow-control priority
View all Netgear XSM4324CS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1006 highlights
M4300 Intelligent Edge Series Fully Managed Stackable Switches Command example: The following example enables PFC on an interface: (NETGEAR Switch) (config) #interface te1/0/1 (NETGEAR Switch) (config-if-Te1/0/1) #datacenter-bridging (NETGEAR Switch) (config-if-dcb) #priority-flow-control mode on no priority-flow-control mode Use this command to disable PFC. Format Mode no priority-flow-control mode Datacenter-Bridging Config mode priority-flow-control priority Use this command to enable the priority group for lossless (no-drop) or lossy (drop) behavior on an interface. You can enable up to two lossless priorities on an interface. You must configure the same no-drop priorities across the network to ensure end-to-end lossless behavior. The command does not take effect on interfaces on which PFC is not enabled. VLAN tagging must be enabled on the interface to carry the dot1p value through the network. Additionally, mapping between dot1p and the queues must be set to one-to-one. Default Format Mode drop priority-flow-control priority priority-list {drop | no-drop} Datacenter-Bridging Config mode Command example: The following example sets priority 3 to no drop behavior: (NETGEAR Switch) (config) #interface te1/0/1 (NETGEAR Switch) (config-if-Te1/0/1) #datacenter-bridging (NETGEAR Switch) (config-if-dcb) #priority-flow-control mode on (NETGEAR Switch) (config-if-dcb) #priority-flow-control priority 1 no-drop Data Center Commands 1006 CLI Command Reference Manual