Netgear XSM4324CS CLI Manual Software Version 12.x - Page 450
GARP Commands
View all Netgear XSM4324CS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 450 highlights
M4300 Intelligent Edge Series Fully Managed Stackable Switches show private-group This command displays information about a private group. If you do not specify a group name, group identifier, or port, the command displays information about all private groups. Format Mode show private-group [private-group-name | private-group-id | port unit/slot/port] Privileged EXEC Term Description Interface A valid slot and port number separated by forward slashes. Port VLANID The VLAN ID that is associated with the port. Private Group ID The identifier of the private group (from 1 to 192). Private Group Name The name of the private group. The name string can be up to 24 bytes of non-blank characters. Private Group Mode The mode of the private group. The mode can be either isolated or community. GARP Commands This section describes the commands you use to configure Generic Attribute Registration Protocol (GARP) and view GARP status. The commands in this section affect both GARP VLAN Registration Protocol (GVRP) and GARP Multicast Registration Protocol (GMRP). GARP is a protocol that allows client stations to register with the switch for membership in VLANS (by using GVMP) or multicast groups (by using GVMP). set garp timer join This command sets the GVRP join time per GARP for one interface, a range of interfaces, or all interfaces. Join time is the interval between the transmission of GARP Protocol Data Units (PDUs) registering (or reregistering) membership for a VLAN or multicast group. This command has an effect only when GVRP is enabled. The time is from 10 to 100 centiseconds. The value 20 centiseconds is 0.2 seconds. Default Format Mode 20 set garp timer join centiseconds Interface Config Global Config Switching Commands 450 CLI Command Reference Manual