2015 Polaris Victory Vision Owners Manual - Page 95
2015 Polaris Victory Vision Manual
Page 95 highlights
Maintenance Elevating the Motorcycle WARNING! Serious injury or death can occur if the motorcycle tips or falls. Make sure the motorcycle will not tip or fall while elevated or while on the sidestand. Some procedures require raising the motorcycle to remove weight from the component being inspected. Elevate the motorcycle by placing a stable, flat platform jack or lift mechanism on a firm, flat surface and lifting under the engine crankcase. The platform should be a minimum of 12 inches (30 cm) square. DO NOT attempt to lift the motorcycle without proper equipment. Always secure the motorcycle properly before lifting so it cannot tip or fall when elevated. Road Test Before returning the motorcycle to regular use, perform a road test in a safe area. Pay special attention to the proper fit and operation of all serviced components. Make any corrections or additional adjustments promptly to ensure safe, reliable and enjoyable vehicle performance. Fastener Torque Refer to the service manual or an authorized VICTORY dealer for procedures and fastener torques not listed in this manual. Windshield Screws 36 in-lbs (4 Nm) Handlebar End Cap Screws 84 in-lbs (10 Nm) Switch Screws 25 in-lbs (3 Nm) Front Fender 8 ft-lbs (11 Nm) Front Brake Caliper Mounting Screws 31 ft-lbs (42 Nm) Rear Axle Nut (Apply grease to threads) 65 ft-lbs (88 Nm) Front Axle Pinch Bolts 17 ft-lbs (23 Nm) Front Axle 52 ft-lbs (71 Nm) 93