2015 Polaris Victory Vision Owners Manual - Page 44

2015 Polaris Victory Vision Manual

Get 2015 Polaris Victory Vision PDF manuals and user guides View all 2015 Polaris Victory Vision manuals

Page 44 highlights

Pre-Ride Inspections Engine Oil Level The oil fill cap/dipstick is located on the right side of the vehicle. Always use the recommended oil. See page 113. Tip: The engine must be at normal operating temperature when checking the oil level. 1. Place the transmission in neutral. 2. Start the engine and allow it to idle for several minutes. 3. Stop the engine and wait 3-5 minutes before checking the oil level. 4. On level ground, straddle the motorcycle and bring it to the fully upright position. 5. Remove the oil fill cap/dipstick and wipe it clean. Reinstall the dipstick and turn the cap clockwise until it seats. 6. Remove the dipstick and view the oil level. 7. Add or remove oil as needed to bring the level into the safe operating range (between the FULL and ADD marks) on the dipstick. Oil Fill Cap/Dipstick Safe Range WARNING! Operating the engine with too much or too little oil can cause serious engine damage or engine seizure, which could result in loss of control and serious injury or death. Do not operate the motorcycle with the oil level above the FULL mark or below the ADD mark. Fuel Level 1. On level ground, straddle the motorcycle and bring it to the fully upright position. 2. Turn the ignition switch to the ON or ACC position. Observe the fuel level in the fuel gauge. 3. Refuel as needed. See page 113 for fuel specifications. Fuel Gauge 42 {

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
  • 107
  • 108
  • 109
  • 110
  • 111
  • 112
  • 113
  • 114
  • 115
  • 116
  • 117
  • 118
  • 119
  • 120
  • 121
  • 122
  • 123
  • 124
  • 125
  • 126
  • 127
  • 128
  • 129
  • 130
  • 131
  • 132
  • 133
  • 134
  • 135
  • 136
  • 137
  • 138
  • 139
  • 140
  • 141
  • 142
  • 143
42
Pre-Ride Inspections
Engine Oil Level
The oil fill cap/dipstick is located on the right side of the
vehicle. Always use the recommended oil. See page 113.
Tip:
The engine must be at normal operating temperature
when checking the oil level.
1.
Place the transmission in neutral.
2.
Start the engine and allow it to idle for several min-
utes.
3.
Stop the engine and wait 3-5 minutes before check-
ing the oil level.
4.
On level ground, straddle the motorcycle and bring
it to the fully upright position.
5.
Remove the oil fill cap/dipstick and wipe it
clean. Reinstall the dipstick and turn the
cap clockwise until it seats.
6.
Remove the dipstick and view the oil level.
7.
Add or remove oil as needed to bring the
level into the safe operating range
(between the FULL and ADD marks) on
the dipstick.
WARNING!
Operating the engine with too much or too little oil can cause serious engine damage or
engine seizure, which could result in loss of control and serious injury or death. Do not operate the
motorcycle with the oil level above the FULL mark or below the ADD mark.
Fuel Level
1.
On level ground, straddle the motorcycle
and bring it to the fully upright position.
2.
Turn the ignition switch to the ON or ACC
position. Observe the fuel level in the fuel
gauge.
3.
Refuel as needed. See page 113 for fuel
specifications.
Oil Fill Cap/Dipstick
Safe Range
{
Fuel Gauge