2015 Polaris Victory Vision Owners Manual - Page 65
2015 Polaris Victory Vision Manual
Page 65 highlights
Maintenance Engine Oil / Filter Change 8. Start the engine and allow it to idle for several minutes. Stop the engine. NOTICE: After an oil change, the low oil pressure indicator remains illuminated longer than usual before going out. Revving the engine while the low oil pressure indicator is illuminated can damage the engine. 9. Stop the engine. Check for leaks around the drain plug and oil filter. 10. Check the oil level and adjust if needed. 11. Recycle the used oil and filter properly. Engine Oil Capacity at Oil Change (including filter) Engine Oil Capacity at Oil Change (not including filter) 4.5 qt. (4.25 liter) (approximately) 4.0 qt. (3.8 liter) (approximately) Oil Check/Fill 1 qt. (.9 l) (approximately) Air Filter Inspect the air filter often if riding in unusually wet or dusty conditions. Do not apply air filter oil to this air filter. Tabs 1. Remove the two air filter retaining screws. 2. Pull the lower edge of the filter toward the front of the motorcycle, then lower it to release the two tabs at the top edge. Remove the filter. 3. Clean the filter sealing surface on the frame. Screws 4. Install the new air filter, engaging the tabs at the top of the filter with the filter case. 5. Reinstall the retaining screws. Torque: 87 in-lbs (10 Nm) 63