2015 Polaris Victory Vision Owners Manual - Page 92
2015 Polaris Victory Vision Manual
Page 92 highlights
Maintenance Headlamp Aim Adjustment The high beam should shine straight forward. The low beam will spread more toward the right (U.S./Canada). 1. Verify that tire pressure is at specification. See 25 ft. (7.6 m) page 79. Verify that rear suspension ride height (preload) is at specification. See page 68. Center Mark 2. Position the motorcycle on a level surface with X the headlight approximately 25 ft. (7.6 m) from a wall. Measure the distance from the floor to the center of the headlight and make a mark on the wall at the same height. 3. Sit in the operator's seat. Bring the motorcycle to the fully upright position. 4. Move the ignition switch to the ON position and switch the headlamp to high beam. Observe the headlight aim on the wall. The top of the beam should be slightly below the mark on the wall. 5. Remove the windshield trim panel. See page 85. Reach through the opening in the headlamp housing mount. 6. To lower the headlamp beam, turn the knob clockwise (as viewed from the operator's seat). Knob Access 7. To raise the headlamp beam, turn the knob counterclockwise. Lower Raise 90