2015 Polaris Victory Vision Owners Manual - Page 48

Pre-Ride Inspections Hydraulic Clutch 1. Position the motorcycle on level ground in the fully upright position. Position the handlebars so that the clutch fluid reservoir is level. 2. View the fluid level through the sight glass. The fluid should be clear. Replace cloudy or contaminated fluid. 3. The fluid level should be at or above the top of the sight glass. Add DOT 4 brake fluid as needed. See page 73. 4. Squeeze and release the clutch lever. It should move freely and smoothly, and it should return to the rest position quickly when released. If the lever fails to perform as stated, service the lever before riding. 5. Check for any signs of clutch fluid leaks around the hoses, fittings, fluid reservoir and slave cylinder located at the rear of the left engine (primary) cover. Minimum Level Slave Cylinder Mechanical Clutch 1. Squeeze the clutch lever toward the handlebar and release it. It should move freely and smoothly, and it should return to the rest position quickly when released. If the lever fails to perform as stated, service the clutch lever before riding. 2. Freeplay (gap) is the amount of lever movement from the rest position to the point of cable resistance. Clutch lever freeplay should be 0.5-1.5 mm. Measure the gap between the clutch lever and the lever housing. Adjust clutch lever freeplay if necessary. See page 74. Lever Housing 0.5-1.5 mm Freeplay Clutch Lever Tip: The starter interlock switch is dependent on the clutch lever freeplay being set correctly to ensure activation of the clutch safety switch. 46