2015 Polaris Victory Vision Owners Manual - Page 76
2015 Polaris Victory Vision Manual
Page 76 highlights
Maintenance Hydraulic Clutch Fluid 1. Straddle the motorcycle and bring it to the fully upright position. Position the handlebars so that the fluid reservoir is level. 2. Wipe the fluid container and the area around the reservoir cover with a clean cloth. 3. If the fluid level is low, check hoses, lines and the slave cylinder for leaks. 4. To add fluid, remove the three reservoir cover screws. Remove the cover and diaphragm. Carefully add fluid to the top of the sight glass. 5. Reinstall the diaphragm, cover and screws. Torque: 25 in-lbs (3 Nm) Minimum Level 6. Wipe away any fluid spills. Check for signs of fluid leaks around hoses, fittings, reservoir, and slave cylinder. Check for deterioration of hoses. Mechanical Clutch Lever Freeplay 1. Remove the right side access cover. 2. Hold the clutch cable and loosen the adjuster lock nut. 3. While holding the cable, turn the cable adjuster inward or outward until clutch lever freeplay is 0.5-1.5 mm. 4. While holding the cable, tighten the adjuster lock nut securely. 5. Reinstall the right side cover. 6. Verify that the safety switch activates properly. The engine should not start in gear with the clutch lever released. 0.5-1.5 mm Freeplay Tip: The starter interlock switch is dependent on the clutch lever freeplay being set correctly to ensure activation of the clutch safety switch. 74