2015 Polaris Victory Vision Owners Manual - Page 75
2015 Polaris Victory Vision Manual
Page 75 highlights
Maintenance Throttle Cable Lubrication Lubricate control cable ends at the intervals recommended in the periodic maintenance table beginning on page 60. NOTICE: External casings are factory-lubricated. Additional lubrication could be detrimental to cable performance. Verify proper routing and smooth movement. Inspect for damage to the external casing, and inspect exposed cable wire for fraying, kinks or corrosion. Replace any damaged, sticky or sluggish cable. 1. Disconnect the cable at the throttle body. 2. Apply a light film of VICTORY All Purpose Grease or equivalent to the barrel end. 3. Reconnect the cable and adjust freeplay as needed. Cruise Control Cable Inspection (if equipped) 1. Remove the right side access cover. 2. Inspect the throttle body end of the cruise control cable for fraying and be sure the end is secured in the bracket. Cruise Control Cable Hydraulic Clutch Lever Lubrication Lubricate the pivot bushing at the intervals recommended in the periodic maintenance table beginning on page 60. Also lubricate any time binding is evident. Use VICTORY All Purpose Grease or equivalent. Hydraulic Clutch Fluid Check the hydraulic clutch fluid level. See page 46. The fluid level should be at or above the top of the sight glass. Add fluid as needed. Replace cloudy or contaminated fluid. Use DOT 4 brake fluid in the hydraulic clutch reservoir. Use fluid only from a sealed, clean container. Review the brake fluid precautions on page 76. Do not operate the clutch while the reservoir cover is removed. Fluid could overflow from the reservoir and cause air to enter the fluid system. WARNING! Using the wrong fluid or allowing air or contaminants into the fluid system can damage the system seals or result in a malfunction that could lead to serious injury or death. Clutch Lever Bushing 73