Denon AVR-4306 Owners Manual - Page 69
Power, Room Eq, Night, Zone2/3/rec Select, Function
View all Denon AVR-4306 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 69 highlights
Advanced Operation Multi-source recording / playback 2 Playing one source while recording another (REC OUT mode) 1 Press the ZONE2/3/REC SELECT button until "ZONE2 SOURCE" appears on the display. 2 With "ZONE2 SOURCE" displayed, turn the FUNCTION knob until "RECOUT SOURCE" appears on the display. • The REC indicator lights. DVD RECOUT SOURCE The function switches as shown below when the FUNCTION knob is turned. ZONE2 SOURCE ZONE2 TUNER ···· ZONE2 V.AUX RECOUT V.AUX RECOUT VCR-2 ···· RECOUT SOURCE 3 With "RECOUT SOURCE" displayed, turn the FUNCTION knob to select the source you wish to record. Last function memory Advanced Operation Initialization of the microprocessor • This unit is equipped with a last function memory which stores the input and output setting conditions as they were immediately before the power is switched off. This function eliminates the need to perform complicated resetting when the power is switched on. • The unit is also equipped with a back-up memory. This function provides approximately one week of memory storage from when the main unit's power switch is off and with the power supply cord disconnected. • In very rare instances, the AVR-4306 internal microprocessor might lock up, or otherwise cause mis-operation. This might be caused due to an AC line surge or line spike noise, or by static electric discharge on or nearby the unit, or to connected components. If the condition cannot be corrected by powering off the unit, including disconnection of the power supply cord for a period of ten minutes and subsequent re-connection, then the unit may have to be re-initialized. Doing so will restore the microprocessor to its original out-of-the-box state, with all custom memories and settings erased, and the original factory default settings restored. Only use this procedure if you are sure that the microprocessor requires re-initialization. 1 Switch off the unit using the main unit's POWER switch. 2 Hold the following ROOM EQ button and NIGHT button, and turn the main unit's POWER switch on. 3 Check that the entire display is flashing with an interval of about 1 second, and release your fingers from the 2 buttons. • The microprocessor will be initialized. 4 Set the recording mode. For operating instructions, refer to the manual of the component on which you want to record. • If step 3 does not work, start over from step 1. • If the microprocessor has been reset, all the settings are reset to the default values (the values set upon shipment from the factory). • To cancel, turn the FUNCTION knob and select "SOURCE". • Recording sources other than digital inputs selected in the REC OUT mode are also output from the ZONE2 preout terminals. • If and only if the digital signal being input from the digital input terminal (optical/coaxial) is a PCM signal, it is output from the analog REC OUT terminals. • When "DENON LINK" is assigned at "Digital In Assign", it is not possible to output the PCM signal and Network Audio signals (Internet radio music server, USB) being input from the digital audio input terminal from the analog REC OUT terminals ( page 67). • When the REC OUT mode is selected, the ZONE2 button on the remote control unit cannot be operated. • Network Audio (Internet radio, music server or USB) signals are not output from the OPTICAL 3 OUT and OPTICAL 4 OUT terminals. 64