Denon AVR-4306 Owners Manual - Page 28

Connecting Other Sources ZONE2 / ZONE3 speaker out connections • When the surround back's power amplifier is assigned to the ZONE2 or ZONE3 output channel at "Power Amp Assign" in the "System Setup Menu", the surround back speaker terminals can be used as the ZONE2 or ZONE3 speaker out terminals ( page 61). • The connections diagram below is an example for when the surround back speaker is assigned to the ZONE2 stereo 2 channel. In this case, surround back speaker out can not be used for MAIN ZONE. Subwoofer Center speaker Surround speaker systems (A) Surround speaker systems (B) Connection terminal for subwoofer with built-in amplifier IN (subwoofer), etc. >< (L) (R) > < (L) (R) > < Connecting Other Sources Connecting the pre-out terminals • Use these terminals if you wish to connect external power amplifier(s) to increase the power of the front, center, surround and surround back sound channels, or for connection to powered loudspeakers. • When using only one surround back speaker, connect it to the left channel. Power amplifier B CENTER A SURROUND BACK L L L R R R A SURROUND L L L R R R B SUBWOOFER A FRONT L L L R R R (L) >< (R) >< Front speaker systems (L) (R) > < ZONE2 Front speaker systems ZONE2 Connecting the power supply cord Power supply cord (Supplied) AC outlets (wall) AC 120 V, 60 Hz NOTE: • Only use the AC OUTLETS for audio equipment. Never use it for hair driers, TVs or other electrical appliances. • Insert the plugs securely. Incomplete connections will result in the generation of noise. AC OUTLETS • SWITCHED (total capacity - 120 W (1 A.)) The power to the outlet is turned on and off in conjunction with the POWER switch on the main unit, and when the power is switched between on and standby from the remote control unit. No power is supplied from this outlet when this unit's power is at standby. Never connect equipment whose total power consumption exceeds 120 W (1 A.). 23