Denon AVR-4306 Owners Manual - Page 61

Advanced Operation MODE SELECTOR IR segment AMP/LAST NUMBER SETUP 3 Press the MODE SELECTOR button for the component you want to learned. Learning is not possible for the AMP, ZONE2, ZONE3 and SYSTEM CALL modes. 4 Press the button that you wish to be learned. • The display will go off and the unit will enter the learning standby mode. If a button that cannot be "learned" is pressed, the IR segment lights and the learning setup mode is cancelled. The AMP/LAST button cannot be "learned". 5 Point the remote control units directly at each other and press and hold in the button on the other remote control unit which you want to "learn". • The display turns on again and the IR segment blinks twice to indicate that the code is successfully captured. Other remote control unit Learning function If an AV component is not a DENON product, or if it cannot be operated via codes provided in the AVR-4306 remote control's internal preset memory, or if its codes cannot be successfully learned by the AVR-4306 remote control, then you should use the remote control that was supplied with that AV component to operate the component. 1 Press and hold the SETUP button for at least three seconds. • The IR segment blinks twice. 2 Press the 9, 7, 5 button (9 → 7 → 5) to select Learning setup. • The IR segment blinks twice, indicating the remote is in Learning set up mode. Other buttons can be "learned" by repeating steps 4 and 5. The mode can be switched by pressing a MODE SELECTOR button. If the IR segment displays one long flash, a leaning error has occurred. Try repeating this step again until a successful capture occurs. 6 Press and hold the SETUP button for at least three seconds to exit programming. • To cancel the learning setup mode, press the SETUP button for at least three seconds. • Do not try to learn anything to the SETUP button. 56 Advanced Operation