Denon AVR-4306 Owners Manual - Page 15
Setup Mic, On/standby, Power - remote
View all Denon AVR-4306 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
Easy Setup and Operation POWER ENTER SETUP MIC SYSTEM SETUP ON/STANDBY CURSOR AMP SYSTEM SETUP CURSOR ON OFF ENTER Connecting a microphone Turning on the power Easy Setup and Operation 1 Connect the microphone for Auto Setup to the SETUP MIC jack on the front panel of the unit. 1 Turn on your subwoofer. Set the volume to halfway and set the crossover frequency to the maximum or Low pass filter off if your subwoofer can adjust the output volume and the crossover frequency Some subwoofers have a standby mode. Be sure to turn this function off before performing the Auto Setup procedure. 2 Mount the auto setup microphone onto a camera tripod, etc., and place it at ear height at the main listening position in the listening room with the sound receptor facing the ceiling. 2 Turn on your monitor (TV). 3 Press the POWER switch. Microphone ¢ ON: The power turns on and the indicator lights. Set the POWER switch to this position to turn the power on and off from the included remote control unit. £ OFF: The power turns off and the indicator is off. In this position, the power cannot be turned on and off from the remote control unit. When placing the microphone, adjust the height so that the microphone's sound receptor is at the height of the ears of the listener. Be sure that at the beginning, the measurement is started with the microphone set up at the main listening position. It is not possible to measure properly if there are any obstacles between the speakers and microphone. Check that there are no obstacles. Please do not stand between or near the speakers and the microphone during the measurements. NOTE: • Do not disconnect the microphone until the settings are completed. • Do not change the connection of speakers or the subwoofer's volume after performing these measurements. 4 Press the ON/STANDBY button on the main unit or ON button on the remote control unit. • When pressed, the power turns on and the display lights. • When pressed again, the power turns off, the standby mode is set and the display turns off. The sound is muted for several seconds, after which the unit operates normally. When ever the ON/STANDBY button is in the standby state, the apparatus is still connected to the AC line voltage. Please be sure to turn off the POWER switch or unplug the cord when you leave home for, say, a vacation. 5 Press the AMP button to select "AMP" mode (only when operating with the remote control unit ( page 24)). 10