Netgear M4300-28G CLI Manual Software Version 12.x - Page 999
iscsi cos enable, no iscsi cos, iscsi
View all Netgear M4300-28G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 999 highlights
M4300 Intelligent Edge Series Fully Managed Stackable Switches targets with initiators. Using the default queue for this homogenous traffic provides the best performance in traffic-burst handling and the most accurate 802.3x Flow Control Pause Frame generation. In these cases, iSCSI Flow Acceleration, which can assign iSCSI frames to queues other than the default queue, might result in lower overall throughput or increased packet loss. Format Mode iscsi cos {vpt vpt | dscp dscp} [remark] Global Config Parameter vpt or dscp remark Description The VLAN Priority Tag or DSCP to assign iSCSI session packets. Mark the iSCSI frames with the configured VPT or DSCP when egressing the switch. Command example: The following example sets the quality of service profile that is applied to iSCSI flows: (NETGEAR Switch)(config)#iscsi cos vpt 5 remark no iscsi cos Use the no iscsi cos command to return to the default. Format Mode no iscsi cos Global Config iscsi cos enable This command enables the assignment of iSCSI flows that you can configure with the iscsi cos command. Format Mode iscsi cos enable Global Config no iscsi cos enable This command disables the assignment of iSCSI flows. Format Mode no iscsi cos enable Global Config Quality of Service Commands 999 CLI Command Reference Manual