Netgear M4300-28G CLI Manual Software Version 12.x - Page 347
history control collection entry can be con d on only one, displays an error message.
View all Netgear M4300-28G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 347 highlights
M4300 Intelligent Edge Series Fully Managed Stackable Switches rmon collection history This command sets the history control parameters of the RMON historyControl MIB group. Note: This command is not supported on interface range. Each RMON history control collection entry can be configured on only one interface. If you try to configure on multiple interfaces, the switch displays an error message. Format Mode rmon collection history index-number [buckets number | interval seconds | owner string] Interface Config Parameter Description History Control Index An index that uniquely identifies an entry in the historyControl table. Each such entry defines a set of samples at a particular interval for an interface on the device. The range is 1 to 65535. History Control Data Source The source interface for which historical data is collected. History Control The requested number of discrete time intervals over which data is to be saved. The range is 1 to Buckets Requested 65535. The default is 50. History Control The number of discrete sampling intervals over which data shall be saved. This object is read-only. Buckets Granted The default is 10. History Control Interval The interval in seconds over which the data is sampled. The range is 1 to 3600. The default is 1800. History Control Owner The owner string associated with the history control entry. The default is monitorHistoryControl. (NETGEAR Switch) (Interface 1/0/1)# rmon collection history 1 buckets 10 interval 30 owner myOwner Command example: (NETGEAR Switch) (Interface 1/0/1-1/0/10)#rmon collection history 1 buckets 10 interval 30 owner myOwner Error: 'rmon collection history' is not supported on range of interfaces. Utility Commands 347 CLI Command Reference Manual