Netgear M4300-28G CLI Manual Software Version 12.x - Page 658
ip address dhcp, no ip address, ip address dhcp client-id
View all Netgear M4300-28G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 658 highlights
M4300 Intelligent Edge Series Fully Managed Stackable Switches Command example: The following example configures the subnet mask with an IP address in the / notation on interface 0/4/1. (NETGEAR Switch) #config (NETGEAR Switch) (Config)#interface 0/4/1 (NETGEAR Switch) (Interface 0/4/1)#ip address 192.168.10.1 /31 no ip address This command deletes an IP address from an interface. The value for ipaddr is the IP address of the interface in a.b.c.d format where the range for a, b, c, and d is 1-255. The value for subnetmask is a 4-digit dotted-decimal number which represents the Subnet Mask of the interface. To remove all of the IP addresses (primary and secondary) configured on the interface, enter the command no ip address. Format Mode no ip address [ipaddr subnetmask [secondary]] Interface Config ip address dhcp This command enables the DHCPv4 client on an in-band interface so that it can acquire network information, such as the IP address, subnet mask, and default gateway, from a network DHCP server. When DHCP is enabled on the interface, the system automatically deletes all manually configured IPv4 addresses on the interface. To enable the DHCPv4 client on an in-band interface and send DHCP client messages with the client identifier option, use the ip address dhcp client-id configuration command in interface configuration mode. Default Format Mode disabled ip address dhcp [client-id] Interface Config Command example: The following example enables DHCPv4 on interface 0/4/1: (NETGEAR Switch) #config (NETGEAR Switch) (Config)#interface 0/4/1 (NETGEAR Switch) (Interface 0/4/1)#ip address dhcp Routing Commands 658 CLI Command Reference Manual