Netgear M4300-28G CLI Manual Software Version 12.x - Page 506
lacp actor admin state, lacp actor port priority, no portlacptimeout, no lacp actor admin, state
View all Netgear M4300-28G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 506 highlights
M4300 Intelligent Edge Series Fully Managed Stackable Switches no lacp actor admin state passive Use this command to set the LACP actor admin state to active. Format Mode no lacp actor admin state passive Interface Config lacp actor admin state Use this command to configure the administrative value of actor state as transmitted by the Actor in LACPDUs. This command can be used to configure a single interfaces or a range of interfaces. Default Format Mode 0x07 lacp actor admin state {individual | longtimeout | passive} Interface Config Note: This command is applicable only to physical interfaces. no lacp actor admin state Use this command the configure the default administrative values of actor state as transmitted by the Actor in LACPDUs. Note: Both the no portlacptimeout and the no lacp actor admin state commands set the values back to default, regardless of the command used to configure the ports. Consequently, both commands display in the output of the show running-config command. Format Mode no lacp actor admin state {individual | longtimeout | passive} Interface Config lacp actor port priority Use this command to configure the priority value assigned to the aggregation port for an interface or range of interfaces. The valid range for priority is 0 to 65535. Default Format Mode 0x80 lacp actor port priority priority Interface Config Switching Commands 506 CLI Command Reference Manual