Netgear M4300-28G CLI Manual Software Version 12.x - Page 743
ip ospf prefix-suppression
View all Netgear M4300-28G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 743 highlights
M4300 Intelligent Edge Series Fully Managed Stackable Switches Default Format Mode broadcast ip ospf network {broadcast | point-to-point} Interface Config no ip ospf network Use this command to return the OSPF network type to the default. Format Mode no ip ospf network Interface Config ip ospf prefix-suppression This command suppresses the advertisement of the IPv4 prefixes that are associated with an interface, except for those associated with secondary IPv4 addresses. This command takes precedence over the global configuration. If this configuration is not specified, the global prefix-suppression configuration applies. prefix-suppression can be disabled at the interface level by using the disable option. The disable option is useful for excluding specific interfaces from performing prefix-suppression when the feature is enabled globally. Note that the disable option disable is not equivalent to not configuring the interface specific prefix-suppression. If prefix-suppression is not configured at the interface level, the global prefix-suppression configuration is applicable for the IPv4 prefixes associated with the interface. Default Format Mode Prefix-suppression is not configured. ip ospf prefix-suppression [disable] Interface Config no ip ospf prefix-suppression This command removes prefix-suppression configurations at the interface level. When you enter the no ip ospf prefix-suppression command, global prefix-suppression applies to the interface. Not configuring the command is not equal to disabling interface level prefix-suppression. Format Mode no ip ospf prefix-suppression Interface Config Routing Commands 743 CLI Command Reference Manual