Netgear M4300-28G CLI Manual Software Version 12.x - Page 251
Simple Network Time Protocol Commands
View all Netgear M4300-28G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 251 highlights
M4300 Intelligent Edge Series Fully Managed Stackable Switches write memory Use this command to save running configuration changes to NVRAM so that the changes you make will persist across a reboot. This command is the same as copy system:running-config nvram:startup-config. Use the confirm keyword to directly save the configuration to NVRAM without prompting for a confirmation. Format Mode write memory [confirm] Privileged EXEC Simple Network Time Protocol Commands This section describes the commands you use to automatically configure the system time and date by using Simple Network Time Protocol (SNTP). sntp broadcast client poll-interval This command sets the poll interval for SNTP broadcast clients in seconds as a power of two where poll-interval can be a value from 6 to 10. Default Format Mode 6 sntp broadcast client poll-interval poll-interval Global Config no sntp broadcast client poll-interval This command resets the poll interval for SNTP broadcast client back to the default value. Format Mode no sntp broadcast client poll-interval Global Config sntp client mode This command enables Simple Network Time Protocol (SNTP) client mode and may set the mode to either broadcast or unicast. Default Format Mode disabled sntp client mode [broadcast | unicast] Global Config Utility Commands 251 CLI Command Reference Manual