Netgear M4300-28G CLI Manual Software Version 12.x - Page 254
sntp source-interface, show sntp, no sntp server
View all Netgear M4300-28G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 254 highlights
M4300 Intelligent Edge Series Fully Managed Stackable Switches no sntp server This command deletes an server from the configured SNTP servers. Format Mode no sntp server remove {ipaddress | ipv6address | hostname} Global Config sntp source-interface Use this command to specify the physical or logical interface to use as the source interface (source IP address) for SNTP unicast server configuration. If configured, the address of source Interface is used for all SNTP communications between the SNTP server and the SNTP client. The selected source-interface IP address is used for filling the IP header of management protocol packets. This allows security devices (firewalls) to identify the source packets coming from the specific switch. If a source-interface is not specified, the primary IP address of the originating (outbound) interface is used as the source address. If the configured interface is down, the SNTP client falls back to its default behavior. Format Mode sntp source-interface {unit/slot/port | loopback loopback-id | vlan vlan-id} Global Config Parameter unit/slot/port loopback-id tunnel-id vlan-id Description The unit identifier assigned to the switch. Configures the loopback interface. The range of the loopback ID is 0 to 7. Configures the IPv6 tunnel interface. The range of the tunnel ID is 0 to 7. Configures the VLAN interface to use as the source IP address. The range of the VLAN ID is 1 to 4093. no sntp source-interface Use this command to reset the SNTP source interface to the default settings. Format Mode no sntp source-interface Global Config show sntp This command is used to display SNTP settings and status. Format Mode show sntp Privileged EXEC Utility Commands 254 CLI Command Reference Manual