Netgear M4300-28G CLI Manual Software Version 12.x - Page 381
Spanning Tree Protocol Commands
View all Netgear M4300-28G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 381 highlights
M4300 Intelligent Edge Series Fully Managed Stackable Switches no link-flap d-disable max-count This command sets the maximum number of allowed link flaps to its defaults of 5. Format Mode no link-flap d-disable max-count Global Config show link-flap d-disable This command displays the link-flap settings. Format Mode show link-flap d-disable Global Config Term Admin State Duration (in seconds) Max-Count Definition Shows whether the link-flap feature is enabled or not. The maximum period that link flaps are allowed. The maximum number of link flaps that are allowed. Spanning Tree Protocol Commands This section describes the commands you use to configure Spanning Tree Protocol (STP). STP helps prevent network loops, duplicate messages, and network instability. Note: STP is enabled on the switch and on all ports and LAGs by default. If STP is disabled, the system does not forward BPDU messages. spanning-tree This command sets the spanning-tree operational mode to enabled. Default Format Mode enabled spanning-tree Global Config Switching Commands 381 CLI Command Reference Manual