Netgear M4300-28G CLI Manual Software Version 12.x - Page 684
match ip address {access-list-number | access-list-name}, no route-map
View all Netgear M4300-28G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 684 highlights
M4300 Intelligent Edge Series Fully Managed Stackable Switches Command example: The following example configures BGP to redistribute all prefixes within 172.20.0.0 and reject all others: (NETGEAR Switch)(config)# ip prefix-list redist-pl permit 172.20.0.0/16 le 32 (NETGEAR Switch)(config)# route-map redist-rm permit (NETGEAR Switch)(config-route-map)# match ip address prefix-list redist-pl (NETGEAR Switch)(config-route-map)# exit (NETGEAR Switch)(config) router bgp 1 (NETGEAR Switch)(Config-router) redistribute ospf route-map redist-rm no route-map To delete a route map or one of its statements, use the no route-map command. Format Mode no route-map map-tag [permit | deny] [sequence-number] Global Configuration match ip address {access-list-number | access-list-name} Use this command to configure a route map in order to match based on the match criteria configured in an IP access-list. Note that an IP ACL must be configured before it is linked to a route-map. Actions present in an IP ACL configuration are applied with other actions involved in route-map. If an IP ACL referenced by a route-map is removed or rules are added or deleted from that ACL, the configuration is rejected. If there are a list of IP access-lists specified in this command and the packet matches at least one of these access-list match criteria, the corresponding set of actions in route-map are applied to packet. If there are duplicate IP access-list numbers/names in this command, the duplicate configuration is ignored. Default Format Mode No match criteria are defined by default. match ip address {access-list-number | access-list-name} [...access-list-number | access-list-name] Route Map Configuration Parameter access-list-number access-list-name Description The access-list number that identifies an access-list configured through access-list CLI configuration commands. This number is 1 to 99 for standard access list number. This number is 100 to 199 for extended access list number. The access-list name that identifies named IP ACLs. Access-list name can be up to 31 characters in length. A maximum of 16 ACLs can be specified in this match clause. Routing Commands 684 CLI Command Reference Manual