Lantronix S3220 Series User Guide Rev J PDF 34.75 MB - Page 65

Transition Networks ION x222x / x32xx User Guide Access via an Ethernet Network The NID can be managed remotely through the Ethernet network via either a Telnet session or the Web interface. Before this is possible, you must set up the IP configuration for the NID. IMPORTANT It is recommended that you initially set up the IP configuration through the serial interface (USB connection). See "Performing Initial System Setup" on page 56. Otherwise, in order to communicate with the NID across the network for the first time, you must change the network settings (IP address, subnet mask and default gateway address) of your PC to coincide with the defaults of the NID (see "Appendix B: Factory Defaults" on page 534). Make note of the original settings for the PC as you will need to reset them after setting the IP configuration for the NID. Starting a Telnet Session The NID can be controlled from a remote management station via a Telnet session over an Ethernet connection. The NID is controlled and configured through CLI commands. Use the following procedure to connect to and access the NID via a Telnet session. 1. Click Start. 2. Select All Programs > Accessories. 3. Click Command Prompt. The command prompt window displays. 4. At the command line type: telnet where: xx = IP address of the NID 5. Press Enter. The login prompt displays. Note: If your systems uses a security protocol (e.g., RADIUS, SSH, etc.), enter the login and password required by that protocol. 6. Type your login (the default is ION). Note: the login is case sensitive. 7. Press Enter. The password prompt displays. 8. Type your password (the default is private). Note: the password is case sensitive. 9. Press Enter. The command line prompt displays. 33472 Rev. J https://www.transition.com Page 65 of 700